lionfere.blogg.se - Capricorn christmas light tester manually

#CAPRICORN CHRISTMAS LIGHT TESTER MANUALLY HOW TO#
#CAPRICORN CHRISTMAS LIGHT TESTER MANUALLY INSTALL#

Video should be smaller than 600mb/5 minutes.

#CAPRICORN CHRISTMAS LIGHT TESTER MANUALLY INSTALL#

Fisher digital arts and craft studio install disk.

You can only upload a photo or a video.

You can only upload a photo (png, jpg, jpeg) or a video (3gp, 3gpp, mp4, mov, avi, mpg, mpeg, rm).

You can only upload videos smaller than 600MB.

You can only upload photos smaller than 5 MB.

You can only upload files of type 3GP, 3GPP, MP4, MOV, AVI, MPG, MPEG, or RM.

You can only upload files of type PNG, JPG, or JPEG.

We are experiencing some problems, please try again.

Please upload a file larger than 100x100 pixels To test your Christmas lights count the number of wires that make up your light strand and follow instructions for the corresponding number of wires. If the LED does not light up then discard the fuse and replace with a new one. If the LED does not light up, check to make sure the fuse is clean.

If the red LED light lights up then the fuse is good. Hold the fuse in the middle and gently press it against the Fuse Tester. To test the light fuses simply remove the fuses from the light strand. Repeated bulb testing or holding lit bulbs against the light tester for long periods of time will drain the batteries rapidly. If the light bulb still does not light, then discard the bulb. If the light bulb does not light, try readjusting the wire contacts on the base of the bulb and test the bulb again. If the light bulb lights, then it is good. Both of the wire contacts should be touching separate metal plates. Hold the bulb by the tip and gently push the 2 wire contacts against the two metal plates located on the bulb tester. To test the light bulbs simply remove the bulb using the bulb remover. If you are unsure if you have locking bases on your light strand, then refer to the light strand manufacturer’s instructions on bulb removal. These require you to unlock the bulb husk from the base in order to remove the bulb. Note: Some light strands have what is known as a “locking” base or clip. Gently rotate the bulb remover to the left and right until the bulb is loose enough to pull out with your fingers. To remove bulbs using the Bulb Remover, simply insert the metal plate between the bulb husk and the bulb base. If the LED does not flash, check the batteries are correctly installed, clean, and in good condition. If the LED flashes on then off the batteries are okay. Instructions on use and care of the Christmas light tester are included. The Christmas light tester comes with 2 “LR44” watch batteries.

#CAPRICORN CHRISTMAS LIGHT TESTER MANUALLY HOW TO#

Every day is a gift: what i learned about christmas tree, top 28 capricorn light tester how to use capricorn. Replace the batter cover and test the batteries by holding down the push button for 4 seconds.Ĭapricorn Light Tester Bulb. To use the light tester, remove the battery cover and insert the 2 batteries into the battery compartment. The light tester has a built in bulb remover to remove bulbs from the light set easily.

The Christmas light tester will test bulbs, fuses, and the light strand. With a push of a button you can locate your Christmas light string problem. Best Answer: Christmas Light Tester Item Number: TD24 28540 This Christmas Light Tester will allow you to easily find any burned out bulbs on your Christmas lights.